|
Engine & Transmission Accessories
|
Page:
1
2 3 4
Next 
|
 |
Pontiac V8 Timing Cover
NEW!
Cast aluminum cover with timing marks includes water pump backing plate and two coolant inserts. Fits most 1969-79 Pontiac V8 engine models including 350, 400 and 455.
|
 |
Wire Loom Set
Polished aluminum spark plug wire loom fits wires up to 9.5mm. Includes mounting hardware. Set of 2.
|
 |
Wire Separator Set
Black plastic set will fit up to 9mm wires. Includes two of each 2, 3 and 4-hole separators.
|
 |
Timing Covers Seals
Seal works with stamped steel or aluminum covers.
|
 |
Transmission Coolers
Universal coolers reduce operating temperature of the fluid, extend life of the transmission and provide better performance. Use as a stand alone cooler or as an auxiliary unit to increase cooling capacity of a stock system. Increased cooling is recommended when using a high stall converter, or if the vehicle is used for towing. Choose from universal coolers with 3/8" barbed fittings, rubber hose, clamps and mounting kit, or -6AN coolers with standard -6AN male fittings and mounting kit.
|
 |
Aluminum Sprint Motor Plates
Front motor plates are offered in one- and two-piece designs. One-piece version mounts using the lower front mounting holes. Two-piece set uses the lower front mount holes and the water pump mounting holes. ALL38128 and ALL38129 plates are 3/8" thick and have 19-1/2" center-to-center chassis mounting holes with bushings to allow for minimum engine flex and help with weight transfer. Universal one-piece plate is not drilled for chassis mounts but is staked for a 19-1/2" center-to-center chassis, 1/4" thick x 20-1/2" overall.
|
 |
Transmission Supports For Bert
Transmission supports fasten to the rear tail shaft housing of Bert Late Model Standard and Ball Spline transmissions adding support to bellhousing mounted dry sump oil pumps or directly to the chassis. Multiple holes in brackets offer many different support options.
|
 |
Engine Mount For Small Block Chevy
Aluminum motor mount is centered for standard positioning. 1/4" thick, sold individually.
|
 |
Clevis Kit For Bert Transmission
Aluminum clevises have 3/8"-24 thread to connect Allstar and most other shifters to Bert transmission. Two clevises per kit with jam nuts.
|
 |
Pump Bracket Kit For Bert
Kit adapts KSE belt driven fuel pumps and fuel/PS tandem pumps to Bert bellhousing. Mounting hardware included.
|
|
Page:
1
2 3 4
Next
|
